Monyet LCD meter 12v berlaku untuk sepeda motor dimodifikasi kecepatan odometer tachometer LCD 2-4 speedometer silinder

浅兰:右转,12V正控 绿/红:N档
蓝/黄:转速信号线 粉红:1档
红色:电池正 蓝/红:2档
蓝色:远光,12V正控 绿/黑:3档
绿色:负 黄/红:4档
橙色:左转向,12V正控 黄/白:5档

蓝白:燃油信号线
黑色:正 黄色:传感器正
绿色:传感器负
黑/白:传感器信号
【工作电压】10V-15V
【车速校定】42.5Hz对应60KM/H
【转速校定】166Hz对应10*1000r/min
【燃油校定】E点98Ω,F点8Ω
【电压】低于11.3V欠压符号闪烁,高于11.7V欠压符号不显示
【液晶屏】7色背光短按右键切换(顺序为:红.紫.粉绿.白.蓝.绿.天蓝.)默认为红色
【按键】短按左键,总计小计切换.在小计状态下长按右键3秒小计清零.长按左键车速闪烁.短按右键公英制切换,再短按左键,切换到时钟设置,小时位闪烁,短按左键加1,再短按左键分钟位闪烁,短按右键加1,再短按左键保存退出.

Light blue: Turn right, 12V positive control Green / red: N file
Blue / Yellow: Speed signal Line pink: 1 file
Red: Battery positive Blue / red: 2 files
Blue: High beam, 12V positive control Green / black: 3 files
Green: Negative Yellow / Red: 4 files
Orange: left turn, 12V positive Yellow / white: 5 files
Blue and white: fuel signal line
Black: Positive
Yellow: Sensor positive
Green: Sensor negative
Black / white: sensor signal
【Working voltage】 10V-15V
【Speed calibration】 42.5Hz corresponds to 60KM / H
【Speed calibration】 166Hz corresponds to 10 * 1000r / min
【Fuel calibration】 E point 98Ω, F point 8Ω
【Voltage】 Below 11.3V Undervoltage symbol flashes, above 11.7V Undervoltage symbol is not displayed
【LCD】 7-color backlight Short press the right button to switch (order: red, purple, pink green, white, blue, green, sky blue.) The default is red
Press the left button, the total subtotal switch in the subtotal state, press and hold the right button for 3 seconds to subtotal reset.Long presses the left button speed flashes.Short right press the inch switch, and then press the left button to switch to Clock setting, hour bit blinking, short press left plus 1, and then press the left button minutes blinking, short press right plus 1, and then press the left button to save and exit.